UBI EasyCoder 201 IISA Bedienerhandbuch PDF herunterladen (Seite 149)

148

Intermec Fingerprint 6.13 – Programmer's Guide

6. Printer Setup,

cont'd.

15. PRINTER FUNCTION CONTROL, cont'd.

Continued!

Creating a Setup File

There are two ways of creating a setup file:

• Create a setup file using Intermec Fingerprint instructions:

- OPEN a file for sequential OUTPUT. See chapter 8.3.

- Use a PRINT# statement to enter each parameters you want so

change. The input must follow the stipulated syntax exactly (see

the Intermec Fingerprint 6.13 Reference Manual, SETUP

statement).

- CLOSE the file.

• Use the Toolbox Setup program to create the file.

Changing the Setup using a Setup File

Use a SETUP<filename> statement to change the printer's setup. If

the setup file is stored in another part of the printer's memory than

the current directory, the file name should contain a reference to the

device in question.

In the following example, we will first save the current setup under

a new file name and then make a setup file that changes the size of

the transmit buffer on "uart1:" just a little. Finally, we use the setup

file to change the printer's setup.

10 SETUP WRITE "SETUP1.SYS"

20 OPEN "SETUPTEST.SYS" FOR OUTPUT AS #1

30 PRINT#1,"SERVICE,MEMORY ALLOC,TRANS BUF UART1,310"

40 CLOSE #1

50 SETUP "SETUPTEST.SYS"

RUN

Changing the Setup using a Setup String

A single setup parameter can be changed without creating any file.

The SETUP statement should be followed by a string following

exactly the same syntax as the corresponding parameter in a Setup

file, but without any leading PRINT# statement.

The same change as in the example above would look this way when

using a setup string:

SETUP "SERVICE,MEMORY ALLOC,TRANS BUF UART1,310"

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 180 181

Keine Kommentare

UBI EasyCoder 201 IISA Bedienerhandbuch Seite 149